Bosch sensixx B10L Notice D'utilisation page 12

en
• Do not allow the power cable to come into
contact with the soleplate when it is hot.
• Never aim the steam at people or animals.
Description
1. Boiler´s cap
2. Removable iron pad
3. Mains cable and hose storage compartment
4. Mains cable
5. Steam hose
6. "Steam ready" pilot light
7. "Refill boiler" pilot light
8. Variable steam control (*depending on the
model)
9. Illuminated main power button (0/I)
10. Housing with internal steam generator
11. Temperature control knob
12. Steam release button
13. Iron pilot light
14. Soleplate
15. Steam button lock (*depending on the
model)
16. Filling funnel
17. Carrying handles
Preparations (A)
1. Remove any label or protective covering from
the soleplate.
2. Place the appliance horizontally on a solid,
stable surface. You may remove the iron pad
(2) from the appliance and place the iron on
it on another solid, stable, horizontal surface.
Never rest the iron on the appliance without
the iron pad!
3. Open the boiler´s cap (1). Fill the boiler carefully
using always the funnel, and close the cap
firmly.
Filling with warm water reduces the waiting
time for heating up.
Do not overfill the boiler.
4. Unwind the mains cable (4) fully and plug it
into an earthed socket.
5. Switch the main power button (9) on (position
"I")
6. The "Steam ready" indicator lamp (6) will light
up after approximately 7 minutes, indicating
that the appliance is ready to use.
12
7. This appliance has a water level sensor. The
"Refill boiler" indicator (7) will light when the
boiler is empty.
Refilling the boiler
Attention! Risk of burns!
Be careful when opening the cap, steam
may escape.
If the pilot lamp (7) illuminates :
1. Press the steam button (12) to check that no
more steam is generated. Only then the boiler
should be refilled.
2. Set the appliance switch (9) to the off position
("0") and unplug the steam station from the
mains. Then wait for minimal 2 minutes.
3. Open the cap (1) carefully and slowly. Allow
remaining steam to escape.
4. Refill the boiler using always the funnel. Do
not overfill the boiler.
5. If there is water left around the filling inlet,
please dry with a towel before closing the
boiler.
6. Close the cap firmly.
Important:
• Normal tap water can be used.
To prolong the optimum steam function, mix
tap water with distilled water 1:1. If the tap
water in your district is very hard, mix tap
water with distilled water 1:2.
You can inquire about the water hardness
with your local water supplier.
• To avoid damage and/or contamination of the
boiler, do not use perfumed water, vinegar,
starch, descaling agents, additives or any
other type of chemical product.
Any damage caused by the use of the
aforementioned products, will make the
guarantee void.
• The iron is not designed to rest on its heal.
Please always position it horizontally on the
iron pad (2). The iron pad can be placed into
the specially designed recess on the appliance
or somewhere suitable alongside the ironing
area.
Never rest the iron on the appliance
without the iron pad!.
• During it first use the iron may produce certain
vapours and odours, along with white particles
on the soleplate, this is normal and it will stop
after a few minutes