Kohler K-T14412 Guide D'installation page 4

Valve
Body
Stem
Extension
Spline Adapter
Wall Thickness
5/8" to 1-1/4"
(1.6 cm to 3.2 cm)
2. Install the Handles
NOTE: If the finished wall is less than 5/8" (1.6 cm) thick, no spline
adapter will be used with the installation.
Determine the thickness of the finished wall.
If the finished wall is less than 5/8" (1.6 cm) thick, use the 1" (2.5
cm) long stem extension, 7/8" (2.2 cm) long screw, and the 2" (5.1
cm) long threaded sleeve.
If the finished wall is 5/8" (1.6 cm) to 1-1/4" (3.2 cm) thick, use
the 1038270 hardware kit supplied.
If applicable, slide a spline adapter onto the stem extension.
Place a stem extension on the valve stem. Secure with the screw
provided.
Thread a threaded sleeve onto the valve body.
Apply plumbers putty or other sealant to the back of the
escutcheon according to the putty manufacturer's instructions.
Thread an escutcheon onto the threaded sleeve. Remove any
excess putty or sealant.
Press a handle over the stem extension and move the handle to
the closed position (Hot = Counterclockwise, Cold = Clockwise).
Lever handles should be horizontal when closed.
1013994-2-C
All manuals and user guides at all-guides.com
Wall Thickness
Less than 5/8" (1.6 cm)
Screw
Threaded
Sleeve
Apply plumbers
putty.
4
Escutcheon
Handle
Kohler Co.