Publicité
Les langues disponibles
Les langues disponibles
Setting Up Your Air Purifier
1. Remove your air purifier from the box and take it out of the clear plastic
protective bag.
2. Place your HEPAtech
®
3. Before turning the Air Purifier 'on,' open the front grill.
• For Model 30057A, 30061: To release the front grill, press the buttons
on the side until the front grill slides easily over the buttons. (Refer to Figure
1.)
• For Model 30067A, 30124A: To release the front grill, place your
fingers behind the tabs and pull forward. (Refer to Figure 2.)
4. Next, check the HEPAtech
filter to ensure that it is fully inserted into the filter opening.
5. The carbon pre-filter is mounted inside of the front grill with "hook" tape.
Confirm that it covers the grill vents. (Refer to Figure 3.)
6. Place the filter installation reminder sticker on the inside edge of the front
grill. Circle the month and write the year of installation for the pre-filter and
HEPAtech
filter.
®
7. Replace the filter and front grill. Be sure that the bottom grill tabs are in
position first, and then push the top of the grill forward until it is closed. The
unit is now ready for normal operation. NOTE: This unit will not operate
unless the door is placed in the correct position.
8. Plug the unit into a 120V electrical outlet.
AIR PURIFIER PARTS
HEPAtech
®
Filter
Pre-Filter
Front
Grill
Buttons for
opening the
front grill
Figure 1 - Model 30057A, 30061
Figure 3
©2010 Hunter Fan Company
All manuals and user guides at all-guides.com
Air Purifier on a firm, flat floor.
filter by pressing firmly on all four corners of the
®
Pre-Filter
Front
Grill
Figure 2 - Model 30067A, 30124A
Hook Tape
Grill Vents
Hook Tape
3
HEPAtech
®
Filter
Tabs for
opening the
front grill
08/18/2010
Publicité
