Whirlpool ADN221S Mode D'emploi page 8

The temperature in the device compartment is controlled using the thermostat knob 2 (see
page 1, fig. 1) by turning it to one side or the other. The temperature indication in digits is
shown beside the thermostat knob. The numbers "0, 1, 2, 3, 4, 5" do not mean a specific
temperatures.
The temperature is regulated on the scale of five digits.
0 = Compressor is switched off WARNING! Electric current is not switched off.
1 = highest temperature (lowest cooling)
5 = lowest temperature (highest cooling)
THE TEMPERATURE IN THE DEVICE COMPARTMENT MAY VARY DEPENDING ON
AMBIENT TEMPERATURE, THE AMOUNT OF FOODSTUFFS, THE TEMPERATURE OF THE
FOODSTUFFS, AND HOW OFTEN THE APPLIANCE DOORS ARE OPENED AND CLOSED.
If a room is cool, the appliance cools less. The temperature in the appliance may
therefore rise. Use the thermostat wheel to set a lower temperature.
THE DEVICE COMPARTMENT DEFROSTS AUTOMATICALLY. Drops of ice that form on the back
wall of the device compartment thaw during the time the compressor is not working and the
thaw water runs down the thaw water runoff channel to the tray on top of the compressor,
where it evaporates.
REGULARLY CLEAN THE APPLIANCE.
Remember that when cleaning the appliance you must disconnect the
appliance from the electrical energy supply socket by pulling the plug out of
the electricity outlet.
Protect the appliance inner surfaces and plastic parts from fats, acids and sauces. In case of
•
accidental spills – immediately clean with warm soapy water or dishwashing detergent. Wipe
dry.
Regularly clean the hermetic gaskets of the doors. Wipe dry.
•
Regularly clean the thaw water channel space with a special cleaner 7 for that purpose (Fig. 1).
•
At least once a year clean dust away from the back part of the appliance body and the
•
compressor. A soft brush, electrostatic cloth or vacuum cleaner may be used for cleaning.
DO NOT use detergents containing abrasive particles, acid, alcohol or benzene for cleaning
•
the appliance inner and outer surfaces. DO NOT use for cleaning cloths or sponges that have
coarse surfaces intended for scrubbing. Outer of the doors – glass – clean with agents
intended for glass cleaning.
If the appliance is to be left switched off for an extended period, leave its doors open.
•
CHANGING THE OPENING DIRECTION OF THE DOORS
It is recommended that changing the opening direction of the doors should be done with a
helper. You will need two spanners No. 8 and No. 10 and a Philips head screwdriver.
When changing the opening direction of the doors, YOU CAN NOT lay the appliance horizontally.
Do the actions below in the order they are listed (see page 3, fig. 5):
WARNING! Turn off the appliance and pull the plug out of the electricity supply
socket.
1. In the back part unscrew four screws 21, remove the cover 22 and disconnect the supply
plug 23 of the connection cable;
2. Unscrew four fixing screws 3 of the promotional shield and remove the promotional shield;
TEMPERATURE REGULATION
DEFROSTING, CLEANING AND CARE
7