Publicité
Les langues disponibles
Les langues disponibles
Info
• MAPS Trimmer adjusted on
INFO: the display will show
the vehicle model and control
unit software.
Maps
• By moving the MAPS trimmer,
the display will show the map
set up on the right and the
new map selected will be
flashing on the left. When the
operation is complete, the new
map selected will be shown for
about 3 seconds on the display.
Diag
• MAPS Trimmer adjusted on
DIAG: the display will show the
possible diagnostics messages
» NO ERROR: there are no
errors
All manuals and user guides at all-guides.com
» INJ1 S.C.: injector 1 in short
circuit to the battery
» INJ1 O.C.: injector 1 not
connected to the control
module
» INJ2 S.C.: injector 2 in short
circuit to the battery
» INJ2 O.C.: injector 2 not
connected to the control
module
» VBATT LOW: battery
voltage too low (<11V for 20
consecutive seconds)
» VBATT HIGH: battery
voltage too high (>15.5V for
20 consecutive seconds)
Error
However, if there are errors
when the switch is not in the
diagnostics position, the message
is generic: "ERROR"
Normal operation
• When the key is turned without
• Upon ignition the display
• During normal operation, the
WARNING: this display must
be used when fine tuning the
vehicle, with it stopped.
Working
The Force Master 3 CDI is
preprogrammed with 8 base fuel
curves. The curves are selected
using the switch labeled MAPS.
These curves adjust fuel delivery
based on throttle position and
RPM, providing the right amount
9
ignition for about 3 secs, the
set map appears.
shows the map set and then
the trimmer status.
(Fig. 10)
tachometer
and TPS
status
(Fig. 11)
are shown, as in
the image.
Publicité
