Télécharger Imprimer la page

Toshiba RAS-M10V Serie Manuel D'installation page 9

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 16
Setting of Remote Control
Selector Switch
When two indoor units are installed in the separated rooms, it is not
necessary to change the selector switches.
Remote control selector switch
• When two indoor units are installed in the same room or adjacent two
rooms, if operating a unit, two units may receive the remote control
signal simultaneously and operate. In this case, the operation can be
preserved by setting either one indoor unit or remote control to B set-
ting. (Both are set to A setting in factory shipment.)
• The remote control signal is not received when the settings of indoor
unit and remote control are different.
• There is no relation between A setting/B setting and A room/B room
when connecting the piping and cables.
Remote Control A-B Selection
To separate using of remote control for each indoor unit in case of 2 air
conditioner are installed nearly.
Remote Control B Setup.
1. Press RESET button on the indoor unit to turn the air conditioner ON.
2. Point the remote control at the indoor unit.
3. Push and hold [CHK] button on the Remote Control by the tip of the pencil.
"00" will be shown on the display.
4. Press [MODE] during pushing [CHK]. "B" will show on the display and "00"
will disappear and the air conditioner will turn OFF. The Remote Control B
is memorized.
Note : 1. Repeat above step to reset Remote Control to be A.
2. Remote Control A have not "A" display.
3. Default setting of Remote Control from factory is A.
"B" Display
"00" Display
1110251159.indb 6
1110251159.indb 6
All manuals and user guides at all-guides.com
OTHERS
OTHERS
To switch the TEST RUN (COOL) mode, press RESET button for 10 seconds.
(The beeper will make a short beep.)
This product is designed so that, after a power failure, it can restart automatically
in the same operating mode as before the power failure.
• Press and hold the RESET button for about 3 seconds. After 3 seconds, the
• To cancel the Auto Restart, follow the steps described in the section Auto
PRESET
FAN
6
Test Operation
Hi POWER FILTER
PAP
TIMER OPERATION
RESET button
Auto Restart Setting
Information
The product was shipped with Auto Restart function in the off position.
Turn it on as required.
How to set the Auto Restart
electronic beeper makes three short beeps to tell you the Auto Restart has
been selected.
Restart Function of the owner's manual.
EN
ES
FR
IT
RESET
DE
PT
PL
CZ
RU
CR
HU
TR
NL
GR
SV
FI
NO
DK
RO
BG
EE
LV
SK
SI
12/21/07 11:52:48 AM
12/21/07 11:52:48 AM

Publicité

loading