Publicité
Les langues disponibles
Les langues disponibles
OPERATING INSTRUCTIONS
OPERATING INSTRUCTIONS
Operation Tips
• Note: Test the GFCI before each use:
1. Plug GFCI into power outlet. Indicator should turn
green to show that cord has power.
2. Press test button, green indicator should turn off
to verify that GFCI cut off power to the cord.
3. Press reset button – green indicator should turn
on to show that cord has power again.
4. When GFCI is working properly, green indicator
will turn on when power is applied. If green
indicator turns off, it has detected electric
leakage and the GFCI cut off power to the
appliance.
• If you hear the motor run intermittently when the
trigger is not being squeezed, that is normal. The
pump is priming itself so it is ready to operate when
the trigger is squeezed. Turn off the power washer if
not being used after five minutes.
• The o-rings on the bayonet end of the nozzle should
be cleaned regularly and lubricated with non-water
soluble grease such as petroleum jelly.
• Keep the nozzle cleaning wire for use in unclogging
the nozzle. If you lose the cleaning wire, a
straightened paper clip also works.
How to Avoid Damaging Surfaces
• Damage to surfaced being cleaned occurs because
the impact force of the water pressure exceeds
the durability of the surface. Bare wood can be
penetrated, paint can be peeled off, etc. You can vary
the force of your power washer by controlling:
1. The angle of the surface being cleaned.
2. The distance of the nozzle from the surface being
cleaned.
• NEVER use a narrow high pressure stream of water
on soft surfaces susceptible to damage.
12
95497_IM_BC 111 HS_ENG-FR-SP.indd 12
Adjusting Soap Levels on Foam Cannon
Twist knob to adjust the level of soap as indicated on
the top of the Foam Cannon (H). Twist toward the higher
concentration of bubbles for more soap, or the opposite
direction for less.
Detergents
• Use detergents designed for power washers. These
can be purchased online at our website www.
arblueclean.com. Hardware stores or home centers
also have power washer detergents for different
cleaning projects. The cleaning solution should be the
consistency of water in order to prevent clogging your
detergent bottle and nozzle.
• This system applies detergent under low pressure.
The cleaning power of the detergents is enhanced
when applied with low pressure and enough time is
given to break down dirt and grime. The combination
of low pressure and chemical action is very effective
and can be better than scrubbing if applied properly.
ALWAYS spray detergent on a dry surface. DO NOT
pre-soak area. Wetting the surface first dilutes the
detergent and reduces its cleaning ability. DO NOT
allow detergent to dry on surface. On vertical surfaces
being cleaned, apply detergent to lower surfaces and
work your way up to prevent detergent from causing
streaks in the dirt and grime. Rinse detergent by
pressure washer from bottom up for same reason.
• If a stain is particularly tough, it may be necessary
to reapply the detergent and use a bristled brush to
scrub the stain. Power washing after brushing should
successfully clear the stain.
F
H
2020/5/22 下午2:48
Publicité
