Publicité
Les langues disponibles
Les langues disponibles
RECOMMENDED CUTTING EQUIPMENT FOR CANADA
The following is a list of recommended cutting equipment for Jonsered chain saw models CS 2255. The combinations of
powerhead, bar and chain meet all requirements outlined in the CSA Z62.1 Chainsaws and Z62.3 Chainsaw Kickback standards.
The guide bar nose radius is determined by either the maximum number of teeth in the nose sprocket or the corresponding
maximum nose radius of a solid bar.
As we are listing the maximum guide bar nose radius, you may use a guide bar with smaller nose radius than in our list. For guide
bars of the same length, all sprocket-nose guide bars of the same pitch and having the same number of sprocket teeth may be
considered to have equivalent kickback energy.
A hard nose bar having the same length and nose radius as a sprocket-nose bar may be considered to have equivalent or less
kickback energy than the sprocket-nose bar.
We recommend that you as replacement use the listed bars and chains or "Type C Low-Kickback Saw Chains" which are available
at your dealer.
Bar and chain combinations
Length, inch
Pitch, inch
13
0,325
15
0,325
16
0,325
18
0,325
20
0,325
15
3/8
16
3/8
18
3/8
20
3/8
16
3/8
18
3/8
20
3/8
Note: For the saw chains above (if available) you are free to choose between 0,050" or 0,058" gauge drive links for the
corresponding bar, see the table below
0,050"/1,3 mm
-
0,058"/1,5 mm
H25
Saw chain filing and file gauges
NT988PCD
TECHNICAL DATA
Bar
Gauge, inch
0,058
0,058
0,058
H46
NT980PCD
H42
NT988PCD
Max. nose radius
Type
10T
10T
10T
Jonsered H25
10T
12T
11T
11T
Jonsered H42
11T
11T
11T
11T
Total NT988PCD
11T
Chain
Drive link count
56
64
66
72
78
56
60
68
72
60
68
72
– 39
English
Publicité
