Publicité
Operation | Cleaning and Maintenance
8. Slide the hex screw (13) through the hole in the swing arm support, the holes
in the swing arm and through the sleeve (15) inside the swing arm and secure
it with a flat washer (10), a spring washer (11) and a nut (12). Tighten the nut.
9. Close the end of the swing arm with the cap (9).
Operation
After installation and before first use, take absolutely some test runs. Start out
without load and gradually work up to the highest load, which is determined by the
maximum load of the arm or the winch.
Monitor while test running, if the construction of the swing arm is up to its load
and check, if the screw connections are fitted firmly.
Cleaning and Maintenance
Do not expose the swing arm continuously to moisture.
To keep the hinges well lubricated, regularly apply grease.
7
Publicité
