Publicité
Les langues disponibles
Les langues disponibles
Installation Procedure
Tools necessary
1. Screw driver
2. Hacksaw
3. 70mm dia. hole core drill
4. Spanner (dia. 22, 36mm)
5. Spanner (16, 18, 22, 36mm)
6. Pipe cutter
7. Flaring tool
8. Knife
9. Nipper
10. Gas leakage detector or soap water
11. Measuring tape
12. Reamer
13. Refrigerant oil
Installation Procedure
Before installation
Try to bring the packed unit to the installation place.
When it is inevitable to unpack the unit, be careful not to damage the unit. Wrap it with nylon etc.
After unpacking, be sure to put it with the front side of the unit facing up.
When delivering, don't hold plastic parts like inlet and outlet grill etc.
Installation of outdoor unit
Selection of outdoor unit installation place
Place strong enough to support the unit and will not cause vibration and noise.
Place where discharged wind and noise doesn't cause a nuisance to the neighbors.
Place where is less affected by rain or direct sunlight and is sufficiently ventilated,
or to install a shield.
Place with enough space for smooth air flow.
Fixing of the outdoor unit
Fix outdoor unit using M10 bolt to concrete floor horizontally.
If installed on the wall or on top of a roof, bracket should be fixed securely
to resist earthquake or storms.
Use rubber pad during installation against unit vibration.
All manuals and user guides at all-guides.com
Installation accessories
Following parts shall be field supplied
15
Part name
Adhesive tape
Pipe clip
Connecting hose
Insulation material
Putty
Drain hose
Installation Preparation
Outdoor Unit
Delivery
Facing up
over 30cm
over 10cm
over
over
10cm
15cm
over 60cm
Publicité
