Timer Function - Haier AD122ALEAA Manuel D'instructions, D'installation, D'utilisation Et D'entretien

Operation
C
Operation
Query indoor malfunction history:
In the state of power on or power off, press the CHECK button to enter the malfunction-querying mode of all indoor units
in the group. Then [CHECK] and [UNIT NO.] will display, and the actual indoor numbers will be displayed in some sequence
(unit number is in decimals). At the same time, in the time region, there will be the current malfunction and the latest time
malfunction, the displaying format is [XX:YY], in which XX stands for the current malfunction, if normal, it will display "--";
YY stands for the latest time malfunction. The failure code of every unit will display for 3 seconds. After the failure codes
of all indoor units in the whole group are displayed, the mode will quit automatically.
Clock set
Before setting timer mode, set the clock to the correct time.
Press the CLOCK button. "CLOCK" will begin flashing at the frequency of 2Hz. Press
the clock +/- button to adjust the current time. Then press the
until the proper time comes.
TIMER ON operation:
Press the TIMER button. Each time the button is pressed, TIMER mode in the [TIMER]
display section changes as follows:
[ON] [OFF] [ON][OFF]
Select [TIMER] [ON], and then [TIMER] [ON] flashes. Press the clock +/- button to adjust
the time of TIMER ON, and press the SET button to confirm.
TIMER OFF operation:
Press the TIMER button. Each time the button is pressed, TIMER mode in the [TIMER]
display section changes as follows:
[ON] [OFF] [ON][OFF]
Select [TIMER] [OFF], and then [TIMER] [OFF] flashes. Press the clock +/- button to
adjust the time of TIMER OFF, and press the SET button to confirm.
TIMER ON-OFF operation:
Press the TIMER button. Each time the button is pressed, TIMER mode in the [TIMER]
display section changes as follows:
[ON] [OFF] [ON][OFF]
Select [TIMER] [ON] [OFF], and then [TIMER][ON] flashes. Press the clock +/- button
to adjust the time of TIMER ON, and then press the TIMER button to confirm. [TIMER][ON]
will be constant on and [TIMER] [OFF] flashes.
Press the clock +/- button to adjust the time of TIMER OFF, and press the SET button
to confirm. The time sequence of timer on and timer off will determine the mode is
[TIMER] [ON] [OFF] or [TIMER] [OFF]
the CLOCK button once, current time will display; Press again, [CLOCK] will flash, and
press clock + / - button to adjust the time.
Note:
1.
If the two times are the same, the timer state which is set later will flash, in this case,
timer can not be set.
2. When entering TIMER setting state, if you do not input any button in continuous 10
seconds, the unit will quit from the TIMER mode.
Cancel TIMER operation:
In the timer operation state, press the TIMER button, the unit will quit from the current
timer operation state, and the set data will be memorized, then enter the next timer
mode. When [TIMER] does not display, the timer will be cancelled.
11
[ON][OFF][DAILY] [ ].
[ON][OFF][DAILY] [ ].
[ON][OFF][DAILY] [ ].
[ON]. If you want the current time, press

Timer Function

SET button to confirm