emerio DH-129238 Mode D'emploi page 9

On/standby button
Press the on/standby button to turn on the appliance. Open the air outlet cover manually. The power indicator
light will illuminate still. Press the button again, the appliance will enter into standby.
Mode button
Press the mode button to select your desired mode: dehumidification mode, fan mode or clothes drying mode.
1. Dehumidification mode: the indicator light of "DEH" illuminates. The fan speed can be switched between
low and high. The humidity can be set between 35-85%RH or set to "CO" (Continuous). Press the button
" "/" " to adjust the setting. The digital display shows the set humidity.
1) When the room humidity > set humidity + 3%, the compressor starts working and the fan keeps running
at the set speed.
When the room humidity < set humidity - 3%, the compressor stops working and the fan automatically
turns to low speed.
When the set humidity - 3% ≤ room humidity ≤ set humidity + 3%, the compressor keeps working and
the fan keeps running at the set speed.
2) When the room humidity does not reach the set humidity, the indicator light of "OK" on the control
panel is off. When the room humidity reaches the set humidity, the indicator light of "OK" will be on.
3) The indication display (A) on the front of the appliance will show 3 colors according to the room humidity.
It shows red when the room humidity is higher than 65%RH, green when the room humidity is between
45%RH and 65%RH, and blue when the room humidity is below 45%RH.
4) When the set humidity is "CO", the compressor runs continuously without the limitation of the set
humidity, and the fan speed is adjustable. The digital display shows "CO".
2. Fan mode: the indicator light of "FAN" illuminates. The compressor does not work; the fan speed can be
switched between low and high. The humidity cannot be set and the room humidity (30~90%RH) is shown
on the digital display.
- 8 -