myGEKOgear ORBIT 1120 Manuel D'utilisation Rapide page 7

Power ON
1. Insert the car charger cable into the car's cigarette lighter and the other end into the Micro-
USB port on the device.
2. Make sure to input the microSD Card into the microSD Card slot on device.
3. After turning on, the system will start recording automatically. The LED light will turn flashing
when recording mode has started.
*Reminder: For the first time, please format microSD card before you start recording. Please refer
to page 3 of instructions.
Power Off
Hold down the power button at least 5 seconds to turn off device. To avoid breaking down the
last file recorded, do not eject the SD Card immediately after powering off.
If you need to turn it back on simply hold the power button for at least 3 seconds.
LED
Blue - indicates recording
Red - Indicates charging
Battery Charge
1. Directly connect the car charger with charging cable in USB interface of the device.
2. USB charging, use the USB cable to connect it to the computer.
Micro SD Card Insert and Removal
1. Insert the Micro SD card into the Micro SD card slot on the dash cam.
2. To take out the Micro SD card, please gently press down the Micro SD card and it will pop out
from the slot.
Caution！
•
Please pay attention to the direction of the Micro SD card when inserting.
•
If you are going to upgrade bigger capacity Micro SD card, please refer to the compatible
•
microSD card brands on
•
Please use a high-speed Micro SD card (Class10 or above).
www.mygekogear.com
7
or contact myGEKOgear customer service.