V-TAC VT-6603105 Manuel D'instructions page 11

Table of detailed delivery list of single-phase inverter
N O
1 3KW-2M / 5KW-2M
2 Installatio n bracket
3 Operatio n manual
4
5 Expansio n bo lts M 6*60
6 Co mmunicatio n co nnecto r
7
8
BEFORE INSTALLATION
Installation tools
Table of tools list
N O IN S T A LLA T IO N T O O LS
1
2
3
4
5
6 Straight screwdriver
7
8
9
1 0
INSTALLATION PLACE
Select installation place based on the following considerations:
(1) The height of the installation position should ensure that the line of sight is at the same
level as the LCD for viewing the parameters of inverter conveniently.
(2) Select a well ventilated place sheltered from direct sun radiation and rain.
(3) Allow sufficient space around the inverter to enable easy installation and removal from
the mounting surface and air convection. (See Figure 8).
(4) The ambient temperature of installation should be -25°C~60°C
(5) The installation site should be away from electronic devices which can generate strong
electromagnetic interference.
(6) The inverter needs to be installed on a firm and sturdy surface, such as wall and metal
bracket and so on.
(7) The installation surface should be perpendicular to the horizontal line. (See Figure 9)
(8) The installation should ensure that the inverter is reliably grounded, and the material of
grounded metal conductor should be consistent with the metal material reserved for the
grounding of the inverter.
N A M E
B o lt M 5*20
DC co nnecto r
A C co nnecto r
M arking pen
Electro drill
Hammer
M o nkey wrench
A llen driver
M egger
M ultimeter
Electric iro n
Wire crimper
Q UA N T IT Y
1
1
1
2
3KW-2M / 5KW-2M
1
3KW-2M / 5KW-2M:2 pairs
1
IN S T R UC T IO N
M ark the installatio n ho le
Drill in the bracket o r wall
Hammer o n the expansio n bo lts
Fix the installatio n bracket
Fasten the screws, remo ve and install A C wiring bo x
Fo r A C wiring
M easuring insulatio n perfo rmance and impedance
Check the circuit and A C and DC vo ltage
Weld co mmunicatio ns cable
Crimp DC terminals
11