Publicité
Important! The fitting must be installed, flushed
and tested after the valid norms!
Assembly
Install body with G ¾" outlet pointing downwards.
Depth of fitting: 68 mm to 96 mm.
extension set 28 mm
The ibox is suitable for both bath and shower
application. For shower application only plug the
unused outlet and leave the diverter valve plug in
place.
Note: When installation is complete ensure
that the mixer is turned off!
The pressures of the cold and hot water
connections must be balanced.
Final assembly
Finish set Focus E
Finish set Focus S
Finish set Metris E
Finish set Metris S
Operation
The mixer is activated by pulling the lever
handle.
Move to the left = hot water,move to the right =
cold water.
All manuals and user guides at all-guides.com
English
Technical Data
Operating pressure:
Recommended operating pressure:
MPa
Test pressure:
(1 MPa = 10 bars = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Connections G ½":
Rate of flow:
Hansgrohe single lever mixers can be used
together with hydraulically and thermically
controlled continuous flow heaters if the flow
pressure is at least 0,15MPa.
To adjust the hot water limiter on single lever
mixers, please see page 6.
No adjustment is necessary when using a
continuous flow water heater.
Spare parts see page 3
1
nut
2
cartridge cpl.
3
seal
4
extension set 28 mm
max.1 MPa
0,1 – 0,5
1,6 MPa
max. 80° C
65° C
cold right - hot left
ca.22 l/min 0,3 MPa
95007000
92730000
95008000
32498000
5
Publicité
