Publicité
Les langues disponibles
Les langues disponibles
Use and care
Use the correct tool for your
application. The correct tool will do the
job better and safer.
Do not use the tool if the switch does
not turn it on and off. Any tool that
cannot be controlled with the switch is
dangerous and must be repaired.
Store idle tool out of the reach of
children and do not allow persons
unfamiliar with the tool or these
instructions to operate the tool. Tools
are dangerous in the hands of
untrained users.
Maintain tools. Check for
misalignment or binding of moving
parts, breakage of parts and any other
condition that may affect the
operation. If damaged, tool repaired
before use. Many accidents are caused
by poorly maintained tools.
Use the tool, accessories, etc., in
The tool is intended for the accurate fransfer of a plumb point from ceiling to floor.
Inserting/Replacing the Battery
Use only alkaline batteries.
Open the battery cover 2 by pulling the
battery door towards back of tool. When
inserting, pay attention to the correct
polarity according to the representation
on the inside of the battery
compartment.
Always use batteries with the same
power rating and from the same
manufacturer.
All manuals and user guides at all-guides.com
accordance with these instructions
and in the manner intended for the
particular type of tool, taking into
account the working conditions and
the work to be performed. Use of the
tool for operations different from those
intended could result in a
hazardous situation.
Have your tool serviced by a qualified
repair person using only identical
replacement parts. This will ensure that
the safety of the tool is maintained.
Develop a periodic maintenance
schedule for tool. When cleaning a
tool be careful not to disassemble any
portion of the tool since internal wires
may be misplaced or pinched or may
be improperly mounted. Certain
cleaning agents such as gasoline,
carbon tetrachloride, ammonia, etc. may
damage plastic parts.
Intended Use
Preparation
For the proper disposal of the used
batteries, see the section
"Environmental Protection".
• Remove the batteries from the
Low Battery Indicator
Laser blinks 8 times between 8 second
intervals.
-6-
Service
SAVE THESE INSTRUCTIONS.
tool when not using it for
extended periods. When storing for
extended periods, the batteries can
corrode and discharge themselves.
Publicité
