Publicité
Les langues disponibles
Les langues disponibles
TABLE ADJUSTMENTS
RISK OF PERSONAL INJURY. Make sure that nothing is on the table and that the workpiece is clamped
down. Falling objects can cause an injury.
You can tilt the table forward from zero (0) to 45 degrees. To adjust:
1. Loosen the two forward tilt levers (A) Fig. 27.
2. Adjust the table to your desired angle. The scale (B) Fig. 27 is located on the side of the table support.
3. Tighten the levers (A) Fig. 27.
4. A positive stop (C) Fig. 28 is provided to return the table to the zero position. Adjust this stop by turning the screw/
stop (C), located under the table. Tighten the locknut to secure the stop.
You can tilt the table right or left. Positive stops are included for 0, 45 and 90 degrees. To adjust:
1. Loosen the table bolt (E) Fig. 29 approximately 1/4 turn with the supplied 14 mm hex wrench.
2. Pull out the spring-loaded detent pin (F).
3. Rotate the table to your desired angle. The tilt scale (G) Fig. 30 is located on the knuckle behind the table. Use this
scale for accuracy. You can allow the detent pin to slide in to the positive stops (0, 45, and 90 degrees), but check
your scale to be sure of the exact angle.
4. Tighten the table bolt.
B
Fig. 27
E
F
T-SLOTS
The drill press table is fitted with two T-slots (L) Fig. 31
for use with various drill press accessories (stop blocks,
fences, or clamps). Use 5/16" (7,9 mm) T-bolts when
attaching your accessory to the table.
All manuals and user guides at all-guides.com
A
Fig. 29
14
C
Fig. 28
Located
under table
Fig. 30
L
Fig. 31
g
Publicité
