Publicité
Les langues disponibles
Les langues disponibles
ROUTINg THE LAMP CORD
1. Line up cord bracket holes (Z) Fig. 21A with holes (Y) in headstock.
2. Wrap cord bushing (A) around lamp cord (B) and place cord strain relief (C) as shown in Fig. 21B. Attach cord strain relief
as shown in Fig. 21B using two 1/4" washers (D) and two
5 mm hex wrench.
3. Wrap cord bushing (F) around cord near hole (G) Fig. 21B in drill press head.
4. Place cord clamp (H) Fig. 22 around bushing and attach to hole (G) with Phillips head screw (I) with Phillips screw
driver (not supplied).
NOTE: Cord should rest as shown in Fig. 23.
Z
Fig. 21A
H
g
Fig. 22
All manuals and user guides at all-guides.com
Y
H
I
F
12
M6x1x12 mm hex head cap screws (E). Use the included
F
g
E
D
C
A
Fig. 23
C
E
B
E
A
Fig. 21B
Publicité
