Napoleon GPFS40 Manuel page 4

4
General Information
EN
This gas appliance was tested and listed to Canadian and American National Standards, ANSI Z21.97-2010
"Standard for Outdoor Decorative Gas Appliance". When an appliance is for connection to a fixed piping
system, the installation must conform with local codes, or in the absence of local codes, with the National
Fuel Gas Code, ANSI Z223.1/NFPA 54, International Fuel Gas Code, Natural Gas and Propane Installation
Code, CSA B149.1, or Propane Storage and Handling Code, B149.2, as applicable.
This appliance should be installed and serviced by a qualified installer to conform with local codes.
Installation practices vary from region to region and it is important to know the specifics that apply to your
area, for example: in Massachusetts State:
• The appliance off valve must be a "T" handle gas cock.
• The flexible connector must not be longer than 36 inches.
The appliance and its individual shut off valve must be disconnected from the gas supply piping system
during any pressure testing of the system at test pressures in excess of 1/2 psig (3.5kPa).
This appliance must be isolated from the gas supply piping system by closing its individual manual shut off
valve during any pressure testing of the gas supply piping system at test pressures equal to or less than
1/2 psig (3.5kPa).
The following clearances to combustible materials must be maintained:
Sides (all around)
• Always keep the appliance area clear and free from combustible materials, gasoline, and other
flammable vapours and liquids.
• Do not locate appliance where it can get
excessively wet.
• Do not use this appliance if any part has been
under water. Immediately call a qualified
service technician to inspect the unit and to
replace any part of the control system and any
gas control, which has been underwater.
www.napoleongrills.com
All manuals and user guides at all-guides.com
- 24 inches (610mm)