PRO-POINT 8364945 Mode D'emploi page 8

V 2.0
INSTALLING OR REMOVING BATTERY PACK
(See Fig.1 Fig.2 )
Fig. 1
1. Always switch off the machine before insertion or removal of the battery pack.
2. To remove the battery pack, pull out the set plate on the machine and grasp both sides of the battery pack
while withdrawing it from the machine.
3. To insert the battery pack, align the tongue in the battery pack with the groove in the housing and slip it into
place. Snap the set plate back into place. Be sure to close the set plate fully before using the machine.
4. Do not use force when inserting the battery pack. If the battery pack does not slide in easily, it is not being
inserted correctly.
CHARGING THE BATTERY PACK
(See Fig.3)
1. Your new battery pack is not charged. You will need to charge it before use.
Note: If you try to charge a battery pack from a just-operated machine, sometimes
the charging light will not come on. If this occurs, let the battery pack cool off for a
while. Then reinsert it and try to charge it once more.
2. When you charge a new battery pack or a battery pack which has not been
used for a long period, it may not accept a full charge. This is a normal condition
and does not indicate a problem. You can recharge the battery pack fully after
discharging it completely a couple of times.
Note: If you wish to charge two battery packs, allow 15 minutes between charging
on the fast charger.
3. Plug the fast charger into you source. Insert battery pack so that the plus and minus terminals on the battery
pack are in the same slides as their respective markings on the fast charger.
4. The charging light will come on and charging will begin. If the charging light goes out soon, remove the
battery pack from the charger and let it cool off for more than one minute. Then reinsert it and try to charge it
once more.
Note: If the charging light goes out within one minute even after repeating this procedure a couple of times,
the battery pack is dead. Replace it with a new one. When the charging light goes out after about one hour,
you may remove the fully charged battery pack.
5. After charging, unplug the charger from the power source.
8
All manuals and user guides at all-guides.com
18V Cordless Impact Driver
Fig. 2
For technical questions call: 1-800-665-8685
8364945
Fig. 3