Panasonic JT-H200PR Serie Mode D'emploi page 9

All manuals and user guides at all-guides.com
3. Appendix
■ ■ ■ ■ Troubleshooting
Symptom Possible Cause
1.Has the battery fully inserted?
No Power in Printer
2.Is the Power Switch on?
1.Is the power turned on?
2.Is the paper set correctly?
3.Are the LED signals lighting red?
4.Is the LED blinking red?
Nothing is printed
5. Are you using Bluetooth?
6.Are you using IrDA?
1.Isn't the thermal head dirty?
The print is faint 2.Are you using the recommended
paper?
The orange or red
LED is lighting The life cycle of the battery pack
may have expired.
even after
charging battery.
■ ■ ■ ■ How to care
How to clean up the thermal head and the rubber roller.
1) Push the paper cover lever to open the paper cover.
2) Wipe off any dust/dirt using the cotton swab with a small amount of alcohol (ethanol).
(Do not use thinner, benzene series or kerosene series.)
3) Close the cover after alcohol volatilizes.
Thermal head
Action
1.Charge the battery pack.
2.Move the Power Switch on.
1.Turn on power.
2.Check the print paper setting.
3.Charge the battery.
4.Make sure that the paper is
setting properly, or close the
paper cover completely.
5.Reduce the distance of the
device and the printer.
6. Adjust the angle of IrDA,
or clean up the window,
or avoid direct sunlight.
1.Clean it up.
2.Check the paper.
Replace the battery pack with a
new one.
Rubber roller
９