Braun VitalScan BP 1750 Mode D'emploi page 4

Product description
A Display
B Memory button («memo»)
C Time/date button
D Start/stop button (I/O)
E Battery compartment
F Battery compartment cover
G Cuff
Inserting batteries
• Use alkaline batteries, type LR 03 (AAA) as supplied
with this product.
• Remove the battery compartment cover (F) and
insert two batteries with correct polarity (see symbol
in the battery compartment (E)).
• New batteries will provide approximately 200
measurements.
• Only discard empty batteries. They should not
be disposed of in the household waste, but at
appropriate collection sites or at your retailer.
Key rules for accurate blood pressure measurement
• Always take readings at the same time of day, ideally in the morning, under the
same conditions.
• Do not measure within 30 minutes after smoking, coffee or tea consumption.
• Take off wrist watch and jewelry before fitting the monitor on the measuring
arm.
• Wait approximately 3 minutes before repeating a measurement.
4
All manuals and user guides at all-guides.com
Taking a measurement
1. While taking a measurement, sit down, relax, keep still, especially the hand of
2. Fasten the monitor on the palm side of your wrist, roughly 2 cm below the palm
3. Press the red I/O button (D).
4. Hold the monitor at heart level.
2x AAA (LR03)
5. At the end of the measurement, a beep sounds and the reading is displayed:
6. Press the start/stop button to turn the product off. Otherwise the product will
the measuring arm, do not move or speak.
line.
Make sure that the cuff (G) fits tightly.
2.
1.
The measurement starts automatically. While measurement is in progress, do
not move or speak.
4.
5.
Upper (systolic) value
Lower (diastolic) value
Pulse
turn off automatically after 2 minutes.
If at any time, you want to stop the measurement, press the red I/O button.
3.
2 cm
6.
5