Publicité
INSTALLATION Continued
3. Place the appliance in the required position and level by
means of the adjustable feet, or shims if the appliance is
not equipped with legs.
4. Where spreader plates are installed between units the
plate is secured at the front by means of the gas manifold
and at the rear by means of the connecting bolts.
5. Connect the gas supply pipe work to the appliance. The
connection may be made to the left or right hand side of
the appliance or optionally at the rear on some models.
Siting
The floor on which the appliance is to be sited must be
capable of adequately supporting the weight of the
appliance and any ancillary equipment.
Units with ovens must be fitted with legs if installed on a
combustible floor.
Appliance Equipped With Casters
A. The installation shall be made with a connector that
complies with the Standard for Connectors for Moveable
Gas Appliances, ANSI Z21.69/CSA 6.16, Addenda Z21.69B-
2006/CSA 6.16B-2006 (or latest edition), and a quick-
disconnect device that complies with the Standard for
Quick Disconnects for Use with Gas Fuel, ANSI Z21.41/
CSA 6.9, Addenda Z21.41A-2005/CSA 6.16A-2005 (or
latest edition).
B. The front casters of the unit are equipped with brakes
to limit the movement of the oven without depending
on the connector and any quick-disconnect device or its
associated piping to limit the appliance movement.
C. Please be aware, required restraint is attached to a
bracket (which is located on the left rear caster), and if
disconnection of the restraint is necessary, be sure to
reconnect the restraint after the appliance has been
returned to its originally installed position.
Appliances Equipped With Legs
Raise front of the unit and block. Do not lay unit on its back.
Position leg insert into leg retainer opening and tap up until
it seats at collar flange. Repeat at rear of unit making sure
all four legs are adjusted to the same height. Legs can be
adjusted to overcome an uneven floor.
Part # 3052000 (09/16/09)
All manuals and user guides at all-guides.com
Installation Instructions for Cuisine
Stub Backguard
Figure 1
5
1
Oven Flue Riser
Optional right or
2
left side.
"X"
1. Remove four 5/16 hex bolts and flat washers from top
rear of unit.
2. Remove flue cap (3), by removing #10-24, self tap screws.
3. With back and front panels (Item 4 & 5) still attached
to the uprights (Item 2) drop the uprights into the
rectangular openings at the rear of the range.
4. Fasten the uprights, (Item 2) to the range with four 5/16"
x 18 bolts and flat washers, (Item 6 & 7 removed in step 1),
using a ratchet extension.
5. If the range is in a battery line-up, fasten units together at
hold marked "X" with 1/4" x 20 bolts, nuts and washers.
6. Reattach the flue cap (3) to the top of the backguard with
self tap screws previously removed.
NOTE: Stub Backguard is shipped installed as standard
equipment on all Cuisine units, unless optional back riser or
high shelf has been ordered.
6
3
7
4
2
Page 11
Publicité
