Qstarz Beyond Navigation BT-Q1200 Ultra Guide D'installation Rapide page 6

English
function. If not, you may need to acquire an optional CF/SD Bluetooth card or
Bluetooth dongle. (The pass code is "0000")
H‐2 Automatically create a shortcut in Bluetooth Manager window
After the pairing complete, the system will then find a quick connect device
"iBT‐GPS" in Bluetooth Manager. In further use, you just need to click it to connect
to this Bluetooth GPS Receiver.
H‐3 Check the Serial Port in Bluetooth Setting
After complete pairing with BT‐Q1200Ultra, please click "Serial Port" to confirm
the assigned COM port. If you use PDA/PC to pair the GPS Receiver, please check
"Outbound COM port".
H‐4 Set correct Serial Port in your map software
Activate your navigation software and make sure to select the correct "Serial
Port".
NOTE 1: In the map software such as TomTom, you might need to change
preference and set "Other Bluetooth GPS" according to PDA/phone
model. In some case please consult map software company to vary the
setting if you have issue on positioning.
NOTE 2: There might be specific setting requirement per navigation software.
Such as Tomtom, please delete other GPS settings under Tomtom
software, and keep one only.
H‐5 Switch off the Bluetooth function
Switch off GPS function in your PDA/Smart phone/PC, and the Bluetooth
connection will be disconnected automatically. Then power off BT‐Q1200Ultra.
I. Function of Auto On‐Off (Power saving mode)
BT‐Q1200Ultra supports Auto On‐Off (Power saving mode). It can automatically
enter sleeping mode after the Bluetooth connectivity is turned off, so the Blue LED
will turn to flash every 5 seconds. Thus you can always power it on with very low
power consumption.
Under power saving mode, when detecting Bluetooth is being connected,
BT‐Q1200Ultra will auto wake up itself and the blue LED will turn to flash every 2
6
All manuals and user guides at all-guides.com