Qstarz Beyond Navigation BT-Q1200 Ultra Guide D'installation Rapide page 2

English
C. Hardware Function
Hardware Function
Power Jack
Power Button (On)
Power Button (Off)
Power Button
(Enable Log mode)
Power Button
(Disable Log mode)
D. Battery Installation
D‐1 Put Battery in place: Press the PUSH button on the bottom side of the unit
and pull out the battery cover. Insert battery in the unit and put battery cover on
to the cabinet, then push down and force it forward to fit firmly.
D‐2 Take Battery out: Press the PUSH button on the bottom side of the unit and
pull out the battery cover. Then take out the battery from the unit.
E. Charging your battery
For the first time using the BT‐Q1200Ultra,
please charge battery until it is fully charged.
Take the power cable and connect it to the
power jack (mini USB type) and recharge
through USB cable, travel charger or car cigarette
adaptor. This will begin to charge the battery.
Charging time is 3 hours typically.
2
All manuals and user guides at all-guides.com
Take the power cable and connect it to the power jack
(mini USB type) for charging only
Press power button and hold for 3 sec to power
BT‐Q1200Ultra on.
Press power button and hold for 3 sec to power
BT‐Q1200Ultra off
After power BT‐Q1200Ultra on, press power button once to
enable log mode. Then BT‐Q1200Ultra would start logging
with the blinking LOG status LED (blue).
Press power button again to disable log mode. The LOG
status LED (blue) would be off, and stop logging.
Description