GYS DIAG-STARTIUM 60-12 Mode D'emploi page 9

This manual contains safety and operating instructions. Read it carefully before using the device for the irst time and
keep it in a safe place for future reference.
GENERAL DESCRIPTION
DIAG-STARTIUM products are designed for charging and starting 12V (6 elements) lead acid batteries (electrolyte, Gel
and AGM) for the model 60-12 and 6V (3 elements), 12V (6 elements) and 24V (12 elements) for the model 60-24:
Assembly - handle and wheels :
POWER SUPPLY
Check that the power and protection (fuse and / or circuit breaker) are compatible with the current required. The
appliance must be positioned so that the plug socket is accessible.
It must be connected to a grounded outlet according to the following recommendation:
Power supply
Protection
Charge power
Start power
Capacity
Recommended cable section in case of extension lead : 3 x 2.5 mm².
CONNECTION AND DISCONNECTION
IMPORTANT! Before connecting to a battery, check that the device is not connected to the power supply and the switch
is OFF.
Secondly, check the polarity of your battery (the fuse breaks if the polarity has been reversed).
Attention: The cables must not be pinched or in contact with hot or sharp surfaces.
Starting and charging a battery connected on the vehicle :
Where the negative pole of the battery is connected to the vehicle chassis
• Connect the red clamp to the positive pole of the battery.
• Connect the black clamp to the vehicle chassis, ensure it is not close to fuel lines and the battery.
• Connect the device to the mains.
• After use, turn the switch to OFF (if any), then disconnect the charger from the mains supply then disconnect the black
clamp and inally the red clamp.
Some vehicles have the positive pole of the battery connected to the chassis, in this case:
• Connect the black clamp to the negative terminal of the battery.
• Connect the red clamp to the vehicle chassis, ensure it is not close to fuel lines and battery.
• Connect the device to the mains.
DIAG-STARTIUM 60-12 / 60-24
DIAG-STARTIUM 60-12
230V - 1 ph
16 A
2000 W
10 000 W
6V
20 - 900 Ah
12V
24V
DIAG-STARTIUM 60-24
-
-
230V - 1 ph
16 A
2000 W
10 000 W
20 - 900 Ah
20 - 900 Ah
20 - 525 Ah
EN
9