Silverline 395008 Mode D'emploi page 7

GB
Description of Symbols
The rating plate on your tool may show symbols. These represent
important information about the product or instructions on its use.
Wear hearing protection.
Wear eye protection.
Wear breathing protection.
Wear head protection.
Wear hand protection.
Read instruction Manual.
Hot Surface
Keep sufficient distance from the machine
This product emits poisonous fume.
Risk of electrocution.
Do not use petrol tools where there is a risk of explosion or
fire from combustible material, flammable liquids, flammable
gases, or dust of an explosive nature
If the engine has been running it will be very hot. DO NOT
TOUCH.
Conforms to relevant legislation and safety standards.
Environmental Protection
Waste electrical products should not be disposed of
with household waste. Please recycle where facilities
exist. Check with your local authority or retailer for
recycling advice.
6
All manuals and user guides at all-guides.com
Specification
Engine Type: ................................................ 4 Stroke OHV
Power: ......................................................... 5.5HP
Fuel Type: .................................................... Unleaded Petrol
Fuel Tank Capacity ...................................... 12L
Maximum Continuous Run Time .................. 12.5Hrs
Sound Level ................................................ 96dB(A)
Maximum RPM............................................4000RPM
The sound intensity level for the operator may exceed 85dB(A) and
sound protection measures are necessary.
As part of our ongoing product development, specifications of
Silverline products may alter without notice.
Generator
Output:
Type: ............................................... Brushless, Revolving Field,
Self-exciting, 2-pole,
Single Phase
AC Voltage
50Hz: .............................................. 110V/230V
Rated Output
50Hz: .............................................. 2.05kVA
Max. Output
50Hz: .............................................. 2.3kVA
Steady State Voltage
Adjust Rate ..................................... Between ± 8%
Steady State Frequency
Adjust Rate ..................................... Less Than 6%
Voltage Waveform
Twist Rate ....................................... Less Than 25%
General Safety
Carefully read and understand this manual and any label attached to
the tool before use. Keep these instructions with the product for future
reference. Ensure all persons who use this product are fully acquainted
with this manual.
Even when used as prescribed it is not possible to eliminate all residual
risk factors. Use with caution. If you are at all unsure of the correct and
safe manner in which to use this tool, do not attempt to use it.
Keep guards in position
• Always keep guards in position, in good working order, correctly
adjusted and aligned. Never attempt to use a tool if any of the supplied
guards are missing. If any guards are damaged, replace before use.
Remove adjusting keys
• Always check to see that keys and adjusting devices are removed from
the tool before use.
Clean the work area
• Accidents can occur where benches and work areas are cluttered or
dirty. Floors must be kept clear and avoid working where the floor is
slippery. If working outdoors, be aware of all potential slip and trip
hazards before using this tool.
Children and pets
• Children and pets should always be kept at a safe distance from your
work area. Lock tools away where children can't get access to them. Do
not allow children or untrained persons to use this tool.