Reese 30946 Instructions page 2

1. The above bed gooseneck comes pre-assembled, adjusted, and ready to install (depending on truck make).
2
5
5
2. If being installed in a GM or Ford truck the unit is ready to install, this step can be
changing the mounting locations is necessary. Start by removing all lynch pins (3), then remove castle nuts (4). Be sure to
keep all handles (2) in the same orientation and same corners of the unit. Move T-Bushings (6) and T-pins (5) to inner slots
as shown below. Be sure not to flip T-Bushings over they need to remain in the same orientation to allow for proper
adjustment. Reassemble all hardware in reverse order of removal. Do not tighten castle nuts fully, they will need to be
adjusted during installation to the truck.
As shipped
GM/FORD trucks
©
2021 Horizon Global America Inc.
Product Instructions
Above Bed Gooseneck
ASSEMBLY AND INSTALLATION
6
3
3
4
2
6
5
Page 2 of 27 30946N
Part Number:
skipped
. If being installed in a RAM
After changes
RAM trucks
09/10/2021
30946
4
Rev. A