Teka DPE Serie Manuel D'instructions page 9

Adjustment of the clock
1) Push the on/off' button for 3 seconds.
2) Adjust the hour digits by pressing '+' or '-'.
3) Push the on/off' button again.
4) Adjust the minute digits by pressing '+' or '-'.
5) After 3 seconds your settings are saved
automatically.
Cleaning and maintenance
During cleaning and maintenance work, make
sure the safety instructions are complied with.
Cleaning the hood body
•
If your kitchen hood is made of stainless
steel, use proprietary cleaners mentioned in
the product instructions.
• If your kitchen hood is painted, use lukewarm
water and a neutral soap.
• Never use metallic scourers, nor abrasive or
corrosive products.
• Dry the kitchen hood using a cloth that does
not produce fibres.
• Do not use vapour cleaners.
Proceed with the following checks before calling the Technical Service:
Problem
The kitchen hood does not
work.
The kitchen hood does
not extract sufficiently or
vibrates.
When exterior gas extraction is not possible, then the kitchen hood may be set to purify the air
by recycling it through active charcoal filters.
The active charcoal filters have an active life of between three to six months, depending on
the individual conditions of use. These filters cannot be washed nor regenerated. They must be
replaced once their useful life comes to an end.
The manufacturer reserves the right to make changes and corrections to its products as it deems
necessary, without altering their basic characteristics.
All manuals and user guides at all-guides.com
For changing the light bulbs please contact
manufacturer's nearest Technical Service.
Problem solving
Possible cause
The mains cable is not
connected to the network.
There is no current in the netw
ork.
Filters are saturated with fat.
Obstruction in the air outlet.
Active charcoal filters (Optional)
Cleaning the metal filters
To remove the filters from their fittings, press
lightly on the locks and then pull them off.
The metal filters can be cleaned by soaking
them in hot water with neutral detergent until
the fat dissolves and then rinsing them under
the tap or using special anti-grease products.
They can also be washed in a dishwasher. In
this case, it is advisable to stack them vertically
to avoid food residues to stick to them.
Cleaning in a dishwasher may damage the
metallic surface (blackening it), although this
will not affect its fat retention capacity.
Once clean, leave them to dry off and then fit
them onto the kitchen hood.
Changing light bulbs
Solution
Connect the mains cable to the
Provide current to the network.
Change or clean the active
charcoal and/or metal filters.
Remove the obstruction.
the
network.