Publicité
Les langues disponibles
Les langues disponibles
9.2 Cleaning of the ventilation grille and
condenser.
The unit requires, for a correct operation, the
cleaning of the toe kick cover, filter and
condenser.
It is recommended to perform the following cleaning
steps very 12 months. If enabled, an audio and visual
message on the display will serve as a reminder. It
is possible to disable the warning signal and see the
time left before the next cleaning has to be done.
Behind the frontal ventilation grille is the condenser.
To clean it use a vacuum cleaner with a soft brush
attachment at maximum power, sweeping it along in
the direction of the vent slits. In case of a significant
dust build up, the toe kick cover can be removed
to allow a more accurate cleaning of the filter.
On the mantenience settings,
installation of the unit and after it has been turned
on, you can set the condenser cleaning warning.
In the case the warning sign is enabled, there will
be an audible signal every 12 months, alerting that
it is time to clean the condenser.
After cleaning it, touch the reset icon in order to
reactivate the warning signal in 12 months.
If you do not want the cleaning signal alert for the
condenser, touch the Off icon.
MAINTENANCE
SERVICE
after the
INFORMATION
Lower condenser.
For cleaning the condenser follow the
instructions:
>
Remove the magnetic grille behind the door.
>
Clean it thoroughly of any dust build up as shown
in the picture, taking care not to damage the
condenser.
The edges of the condenser are extremely
thin and can be sharp, therefore use
adequate protection for hands and arms
when cleaning the condenser.
EN
29
Publicité
