Golden Media Hypercube Mode D'emploi page 29

All manuals and user guides at all-guides.com
12.1.1 Single satellite – direct connection (DVB-S2)
Use this type of configuration if you want to receive a single
satellite with a Single Universal LNB. The coax cable is directly
connected from you STB to the LNB. Please read the section
12.1.1 DVB-S2 configuration to learn how to get into this menu.
The "Reception settings" menu will open up.
Use the up/down-Buttons to navigate to the "Mode" option and
use the left/right-Buttons to select "Single".
Use to the Navigation-Buttons left and right to select the desired
satellite and press the OK-Button. You are taken back to the
"Choose tuner"menu. If you have trouble with "Tune
failed"messages please set the
"Send DiSEqC only on satellite" changes to "yes".
12.1.2 Two satellites via Toneburst A/B (DVB-S2)
Use this type of configuration if you want to receive two satellites
from one LNB each. It does not matter if you use one or two
dishes to achieve this.
Connect the two coax cables form the two LNBs to a so-called
Tone-burst switch and connect the coax cable from the
Tone-burst switch to your STB. Please read the section 12.1
DVB-S2 configuration to learn how to get into this menu.
The "Reception settings" menu will open up.
Use the up/down-Buttons to navigate to the "Mode" option and
use the left/right-Buttons to select "Tone-burst A/B".
For Port A and Port B select the desired satellites just as
described in the Single satellite – direct connection section.
Make sure you know which satellite is connected to which input
on the Tone-burst switch.
If you do not find any services in the transponder scan later,
exchange the two satellites in this list and try again.
Press the OK-Button to save your settings.
29