NAD HTR 2 Mode D'emploi page 7

All manuals and user guides at all-guides.com
Example: Record a Macro to the [0] key to Turn on the NAD receiver,
turn on the DVD player, select the DVD input, and commence
playback:
• On the HTR 2, simultaneously press-and-hold [MACRO] and [0]
(numeric zero); the Learn LED turns steady green.
• Press [AMP]; press [ON]; press [DVD]; press [ON]; press [AMP]; press [1]
(red "DVD"); press [DVD]; press [play] (the Device Key blinks as each
step is added).
• Press [MACRO] again to exit the macro-record mode.
To clear a macro, perform the above steps without entering any functions.
EXECUTING MACROS
To execute a macro, press and release [MACRO]; its key illumination lights
for 5 seconds. While it remains lit, press an HTR 2 key to which a macro has
previously been stored ([0] as in the case illustrated above). The
corresponding macro will run; as each step executes, its "parent" Device
Selector's key flashes lights briefly; when execution is finished, the [MACRO]
key illumination goes out. Pressing any other HTR 2 key while a macro is
executing will abort the macro. Remember that you must hold the HTR 2 so
that its infrared emitter can activate the target components.
NOTE
When a macro executes, a 1 second delay is automatically inserted
between its commands. If you need more than a 1 second delay
between particular commands-for example, to permit a component to
power up completely-you can record "empty" steps into the macro. For
example, if the [TITLE] key is not used for your CD player, you could
record that command into the macro to insert a delay.
KEY-ILLUMINATION TIME-OUT
The HTR 2's key-illumination can be set to remain lit for 0-9 seconds. The
default value is 5 seconds.
To set the illumination time-out, simultaneously press-and-hold for 3
seconds both the HTR 2's [DISP] and the [0-9] key, with the digit
corresponding to the desired time-out duration; the Learn LED will flash
twice to confirm the new setting. When set to zero, the illumination will not
turn on at all.
NOTE
Key illumination is the biggest drain on the HTR 2's batteries. A short
key-illumination time-out will extend battery life appreciably; turning it
off altogether (set it to 0 seconds) will lengthen it still further.
FACTORY RESET
The HTR 2 can be reset to its factory state, deleting all learned commands,
copied and punched-through keys, macros, and other setup information,
reverting all keys to their pre-programmed library commands. To perform a
factory reset simultaneously press-and-hold for 10 seconds the HTR 2's [ON]
and [RTN] keys; the Learn LED will start to flash green. Release [ON] and
[RTN] before the second flash is complete; the Learn LED will turn red,
indicate the remote has been reset.
NOTE
You must release [ON] and [RTN] before the second flash goes out,
otherwise the unit will not reset; should this occur, repeat the full
procedure.