Logitech QuickCam Cordless Mode D'emploi page 6

2
Set Up the Camera
1. Install software first.
Follow on-screen instructions.
2. Install batteries in camera
Refer to the diagram inside
battery compartment.
3. Turn on camera. Press and hold
camera's power button
for two seconds.
Note Power Save is on by
default. Camera turns
itself off after 10 minutes
of inactivity. Press Power
button to turn camera
back on.
4. Insert receiver cable into
USB port when prompted
by software
b
5. Deploy receiver antenna
2
English
.
a
A
.
A
.
c
A
a
b
c
USB connector