Benthaus Onyx Serie Instructions De Montage page 38

7.4 Variable installation possibilities: Overlying
installation
Dimensions in mm
4
R5
2
min.50
1
Minimum distance to adjacent walls
Opening dimensions
Cutout dimensions
Outer dimensions of the hob
Important:
There is a risk of breakage if the hob is canted or
subjected to stress during installation!
38
Instructions for assembly
4
800
750+1
2 4
1 min.50
7.5 Variable installation possibilities: Flush
installation
804+1
3
R7
2 750+1
min.50
1
Glue the sealing tape onto the corner of the supporting
edge of the worktop so that no silicone adhesive can be
pressed under the hob.
Place the hob into the worktop cut-out without any
adhesive and align it. Use shims if necessary
Fill the gap between the hob and the worktop with heat-
resistant silicone adhesive.
Important
Silicone adhesive must not get under the support surface
of the hob. If this occurs it will not be possible to remove
the hob again at a later stage. No liability will be assumed
in the case of failure to observe these instructions.
ENG
3
3
2
min.50
1