Benthaus Onyx Serie Instructions De Montage page 34

34
Operation
4.19 Using the fan
The fan is located in the middle of the hob with the extractor
facing downwards.
Important:
Do not put the cover onto the induction hob! Risk of
burning!
4.19.1 Switching the fan on and off
1. Turn the fan regulator into the required setting 1, 2, 3 or 4.
The symbol for the fan
The intensive power setting 4 operates for 10 minutes, after
which the power level is automatically reduced to power
setting 3.
2. To switch off the function turn the regulator to 0-
Hint
In order to ensure that extraction functions well with tall
cooking pots (e.g. pots used for cooking asparagus), you can
place a wooden spoon under the lid of the pot.
4.19.2 Fan time lag
The fan time lag is used after cooker in order to remove
cooking odours. The fi lter is also dried in the fan.
Setting the fan time lag
1. Turn the regulator to the right until it stops.
The fan time lag of 10 minutes will be activated. The
symbol for the fan time lag will light up
2. The fan time lag of 60 minutes is activated by turning the
regulator again.
3. The time lag function is deactivated by turning the regulator
again.
The fan setting can be freely adjusted or changed when the
fan time lag is switched on.
4.19.3 After run time
The fan motor should continue operating for another 10-20
minutes every time the hob has been used for cooking. When
the fan is switched off after having been in operation for at
least 15 minutes, an automatic time lag at a low setting will
follow for around 15 minutes.
This guarantees optimal functioning and the removal of
remaining cooking steam.
When using a recirculating air fi lter, please always allow for a
stop delay time of 10 - 60 minutes in order to optimally remove
cooking odours.
When the fan is switched on again, in rare cases the odour
molecules present in the fi lter may be combined with steam
so that they are detected again. These remaining odours will
disappear when the fan continues to operate.
Important
When the convection air mode is in operation, ventilation must
be suffi cient in order for the air humidity to be removed.
will light up.
.
ENG