Algam Lighting LIGHT192 Mode D'emploi page 26

CHASE
DELETE CHASES
All Scenes are still available.
1 ∙ Press and hoId the PROGRAM button for 3 seconds.
2 ∙ Press the chase button that you want to delete.
3 ∙ Press and hold the AUTO/DEL button and then press and hold the CHASE button of the have to be deleted.
The LEDs will flash three times.
4 ∙ Release both buttons and the chase will be deleted.
DELETE ALL CHASES
All Scenes are still available.
1 ∙ Press and hold down the BANK
2 ∙ Re-connect the pmver, all chases should be deleted.
MANUAL RUN CHASES
This funcion will enable you to manually step through a selected chase.
1 ∙ Press and hoId the PROGRAM button for 3 seconds to enter programming mode.
2 ∙ Start a chase by selecting one of the six CHASE buttons.
3 ∙ Press the TAP SYNC/DISPLAY button. Each time you press the button, you will step through the chase.
4 ∙ Use BANK
et buttons to scroll through the chases.
5 ∙ Press and hold the PROGRAM button for three seconds to exit programming mode.
AUTO RUN CHASES
1 ∙ Press any or all of the six CHASE button to select the desired chase.
2 ∙ Press and release the AUTO/DEL button. The corresponding LED will flash.
3 ∙ Adjust the Speed and Fade Time to your desired settings. The Chase will run according to your settings.
4 ∙ You can override the speed and fade time by tapping the TAP SYNC/DISPLAY button three times. Then the
chase will run based on the time interval of your taps.
Never adjust Fade time slower than the Speed setting otherwise your
scenes will not be completed before a new step is sent!
and AUTO/DEL buttons while turning power off.
If you wish to include all the chases,
press AUTO/DEL button before selecting chase.
P.26
QUICK QUICK
TIPS