Algam Lighting LIGHT192 Mode D'emploi page 25

CHASE
CHASE PROGRAMMING
You have to program scenes before you can program chases
1 ∙ Press and hoId the PROGRAM button for 3 seconds to enter programming mode.
2 ∙ Choose the CHASE(1-6) to be programmed.
3 ∙ Select the desired scene form any bank. Scenes are run in the order that they are programmed into the chase.
4 ∙ Press the MIDI/ADD button, all the LED will flash 3 times.
5 ∙ Repeat steps 3 and 4 as many as you want .You can record up to 240 scenes into one chase.
6 ∙ Press and hold the PROGRAM Button for 3 seconds to exit programming mode.
ADDING A STEP TO A CHASE
1 ∙ Press and hoId the PROGRAM button for 3 seconds to enter programming mode.
2 ∙ Select the CHASE 1-6 to which you wish to add a step. Press TAP SYNC/DISPLAY and the LCD show the scene
and bank. This is the bank containing the scene you wish to add.
3 ∙ Press TAP SYNC/DISPLAY again and LCD show the Chase that you have selected.
4 ∙ Use the et buttons to scroll through the chase to reach you have selected.
5 ∙ Press MIDI/ADD, the LCD will read one step number higher.
6 ∙ Press the scene button you wish to add.
7 ∙ Press MIDI/ADD again to add new step.
6 ∙ Press and hold the PROGRAM Button for 3 seconds to exit programming mode.
DELETING A STEP IN A CHASE
1 ∙ Press and hoId the PROGRAM button for 3 seconds to enter programming mode.
2 ∙ Select the chase 1 to 6 from which you wish to delete a step.
3 ∙ Press TAP SYNC/DISPLAY and the LCD shows the Chase that have selected.
4 ∙ Use the
et buttons to scroll through the chase to reach the step you wish to delete.
5 ∙ Press AUTO/DEL and the scene will be deleted.
6 ∙ Press and hold the PROGRAM Button for 3 seconds to exit programming mode.
P.25