Algam Lighting LIGHT192 Mode D'emploi page 23

SCENE
SCENE EDITION
This function allows you to make changes in a previous programmed scene.
1 ∙ Press the PROGRAM button for three seconds to enter program mode.
2 ∙ Use BANK et button to select the bank that stores the scene you wish to edit.
3 ∙ Select the scene you want to edit by pressing it's SCENE button.
4 ∙ Use the faders to make your desired adjustments.
5 ∙ Press the MIDI/ADD button then followed by the SCENE button that corresponds to the scene you editing to
store it to memory.
You must select the same scene you selected earlier otherwise you may
SCENE COPY
This allows you to copy the settings of one scene to another.
1 ∙ Press the PROGRAM button for three seconds to enter program mode.
2 ∙ Use BANK et button to locate the bank that stores the scene to copy.
3 ∙ Select desired scene you want to copy by pressing the SCENE button.
4 ∙ Use BANK et n to select the bank where you want to store the copies scene.
5 ∙ Press MIDI/ADD followed by the SCENE Button where you want to copy to.
DELETE SCENE
This function will reset all DMX channels incorporated with a scene to 0.
1 ∙ Select the desired scene to delete.
2 ∙ While pressing and holding AUTO/DEL, press the SCENE button (1 to 8) you want to delete.
ERASE ALL SCENES
This will erase all scenes in all banks. All scenes are reset to O..
1 ∙ Press and hold down PROGRAM and BANK
2 ∙ Re- connect the power, all scenes should be erased.
accidentally record over an existing scene.
buttons while turning power off.
P.23
QUICK QUICK
TIPS