Uline H-10316 Instructions De Montage page 4

7. Using two people, place acrylic panels within frame
and slide vertical bar over acrylic panels. Tighten
bottom lock using Allen wrench. (See Figure 7)
NOTE: Acrylic panels are covered with a
protective film. Peel off film before inserting
panels into frame.
Figure 7
Vertical Bar
8. Insert horizontal bar between posts and slide onto
top row of panels. Tighten locks using Allen wrench.
(See Figure 8)
Figure 8
PAGE 4 OF 15
STARTER DIVIDER ASSEMBLY CONTINUED
Acrylic
Panel
9. Insert post cap into top of post. If necessary, gently
tap post cap with a rubber mallet to insert fully.
Repeat on opposite end. (See Figure 9)
Figure 9
Post Cap
(B)
10. Apply bolt covers to horizontal and vertical bars.
(See Figure 9)
Bolt
Cover
(C)
1122 IH-10316