Toro 55cm Recycler Mode D'emploi page 21

Figure 30
Important:
Position the curved ends of the
blade to point toward the machine housing.
6. Use a torque wrench to tighten the blade bolt
to 82 N∙m (60 ft-lb).
Important:
A bolt torqued to 82 N∙m (60
ft-lb) is very tight. While holding the blade
with a block of wood, put your weight
behind the ratchet or wrench and tighten the
bolt securely. This bolt is very difficult to
overtighten.
Adjusting the Self-Propel
Drive
For Self-Propel-Drive Models Only
Whenever you install a new self-propel cable or if
the self-propel drive is out of adjustment, adjust the
self-propel drive.
1. Turn the adjustment nut counterclockwise to
loosen the cable adjustments
g231390
1. Handle (left side)
2. Adjustment nut
3. Self-propel-drive cables
2. Adjust the tension on the cables
pulling them back or pushing them forward and
holding that position.
Note:
Push the cables toward the engine to
increase the traction; pull the cables away from
the engine to decrease the traction.
3. Turn the adjustment nut clockwise to tighten the
cable adjustments.
Note:
Tighten the nut firmly with a socket or
wrench.
20
(Figure 31).
Figure 31
4. Turn the nut clockwise to
tighten the adjustment.
5. Turn the nut
counterclockwise to
loosen the adjustment.
(Figure
g273506
31) by