Toro 55cm Recycler Mode D'emploi page 14

Bagging the Clippings
Use the grass bag when you want to collect grass and leaf clippings from the lawn.
If the side-discharge chute is on the machine, remove it; refer to
14). If the bag-on-demand lever is in the recycling position, move it to the bagging position; refer to
the Bag-on-Demand Lever (page
Installing the Grass Bag
1. Raise and hold up the rear deflector (A of
2. Install the grass bag, ensuring that the pins on the bag rest in the notches on the handle (B of
3. Lower the rear deflector.
Removing the Grass Bag
To remove the bag, reverse the steps in
Operating the
Bag-on-Demand Lever
The bag-on-demand feature allows you to either
collect or recycle grass and leaf clippings while the
grass bag is attached to the machine.
•
To bag the grass and leaf clippings, press the
button on the bag-on-demand lever and move the
lever forward until the button on the lever pops up
(Figure 18).
Figure 18
1. Bag-on-demand lever (in the bagging position)
•
To recycle or side-discharge the grass and
leaf clippings, press the button on the lever and
13).
Figure 17).
Figure 17
Removing the Grass Bag (page
g027453
13
Removing the Side-Discharge Chute (page
13).
move the lever rearward until the button on the
lever pops up.
Important:
For proper operation, shut off
the engine, wait for all moving parts to stop,
and then remove any grass clippings and
debris from the bag-on-demand door and the
surrounding opening
move the bag-on-demand lever from 1 position
to another.
Figure 19
1. Clean here
Operating
Figure 17).
(Figure 19) before you
g233434
g027454