MCS Master DH 716 Manuel D'utilisation Et De Maintenance page 7

► Is the house electricity on?
en
► Is the room temperature below 5
so, then it is out of the working range of the unit.
CZ
► Ensure the humidistat (or ON/OFF switch) is turned
on.
DE
► Check the water tank is positioned properly in the unit
and it is not full.
► Make sure the air inlet and outlet are not obstructed.
DK
THE UNIT SEEMS TO DO NOTHING:
EE
► Is the filter dusty, contaminated ?
► Is the air intake or outlet blocked up?
ES
► Is the room humidity already quite low?
THE UNIT SEEMS TO DO LITTLE:
FI
► Are too many windows or doors open?
► Is there something in the room producing lots of humi-
FR
dity?
GB
THE UNIT IS TOO NOISY:
► Check whether the unit is sitting on a level surface.
HR
THE UNIT IS LEAKING:
► Make sure the unit is in good shape.
HU
► If you are not using continuous drainage, make sure the
rubber plug (at the bottom of the unit) is in its position.
IT
LT
Error codes on display
Code Cause
LV
E1 The room tempera-
ture sensor (with re-
sin head) is open or
NL
short circuit fault
NO
PL
RO
E2 The system sensor
RU
(with copper head) is
open or short circuit
fault
SE
SI
SK
UA
SE
SI
SK
TR
UA
All manuals and user guides at all-guides.com
C or above 35 C? If
O O
Solution
Checking if the room
temperature sensor
is plugged in properly
on the PCB.
Replace the room
temperature sensor
of room temp.
Replace main PC
board.
The humidity level is
below RH40%
Checking if the sys-
tem sensor is plug-
ged in properly on
the PCB.
Replace the system
sensor
Replace main PC
board.