CLAS OH 5355 Mode D'emploi page 7

All manuals and user guides at all-guides.com
OH 5355 LONG CHASSIS SERVICE JACK 5T L.1505mm
USE
Raising jack
1. Turn handle knob (3-8) clockwise until resistance is felt to close release valve. Do not over-tighten.
2. Place jack directly under abject to be lifted. Make sure saddle takes up weight fi rmly and centrally. Check
positioning under slight load to confi rm jack or load will not slip.
3. Raise jack by pumping handle until desired height is reached. After lifting, secure load by appropriate means.
Do not use jack as the only means of support.
Lowering jack
1. Slowly turn handle knob (3-8) counter-clockwise. Speed of descent is controlled by amount release valve is
turned.
MAINTENANCE
Checking hydraulic oil level
1. Open release valve (Turn handle knob (3-8) counter-clockwise) and push ram to its lowest position.
2. Remove fi ller plug.
3. Fill the clean hydraulic jack oil. Do not use hydraulic brake fl uid.
4. Reinstall fi ller plug.
Lubrication
1. Add lubricating oil to all moving parts as needed.