Black & Decker PRO Serie Mode D'emploi page 6

ENGLISH
• Use auxiliary handles supplied with the tool. Loss of
control can cause personal injury.
• Hold power tool by insulated gripping surfaces when
performing an operation where the cutting tool may
contact hidden wiring or its own cord. Contact with a
"live" wire will also make exposed metal parts of the
power tool "live" and shock the operator.
• Use clamps or another practical way to secure and
support the workpiece to a stable platform. Holding
the work by hand or against your body leaves it unstable
and may lead to loss of control.
• Before drilling into walls, floors or ceilings check for the
location of wiring and pipes.
• Avoid touching the tip of a drill bit just after drilling, as it
may be hot.
Assembly
Warning! Before assembly, make sure that the
tool is switched off and unplugged.
Fitting the side handle and depth stop (Fig. B)
• Turn the grip counterclockwise until you can slide the
side handle (7) onto the front of the tool as shown.
• Rotate the side handle into the desired position.
• Insert the depth stop (6) into the mounting hole as
shown.
• Set the drilling depth as described below.
• Tighten the side handle by turning the grip clockwise.
Fitting a drill bit or screwdriver bit Keyed chuck (Fig. C)
• Open the chuck by turning the sleeve (8)
counterclockwise.
• Insert the bit shaft (9) into the chuck.
• Insert the chuck key (10) into each hole (11) in the side
of the chuck and turn clockwise until tight.
Removing and refitting the chuck (Fig. D)
• Open the chuck as far as possible.
6
All manuals and user guides at all-guides.com
•
•
•
•
•
Use
Selecting the direction of rotation (Fig. E)
For drilling and for tightening screws, use forward
(clockwise) rotation. For loosening screws or removing a
jammed drill bit, use reverse (counterclockwise) rotation.
•
•
Selecting the drilling mode
For drilling in masonry, set the drilling mode selector (4) to
the
For drilling in other materials and for screwdriving, set the
drilling mode selector to the
Setting the drilling depth (Fig. F)
•
•
•
Remove the chuck retaining screw, located in the chuck,
by turning it clockwise using a screwdriver.
Tighten an Allen key into the chuck and strike it with a
hammer as shown.
Remove the Allen key
Remove the chuck by turning it counterclockwise.
To refit the chuck, screw it onto the spindle and secure it
with the chuck retaining screw.
Warning! Let the tool work at its own pace. Do
not overload.
Warning! Before drilling into walls, floors or
ceilings, check for the location of wiring and
pipes.
To select forward rotation, push the forward/reverse
slider (3) to the centre position.
To select reverse rotation, push the forward/reverse
slider to the left.
Warning! Never change the direction of rotation
while the motor is running.
position.
position.
Slacken the side handle (7) by turning the grip
counterclockwise.
Set the depth stop (6) to the desired position. The
maximum drilling depth is equal to the distance between
the tip of the drill bit and the front end of the depth stop.
Tighten the side handle by turning the grip clockwise.