Marklin Digital L88 Mode D'emploi page 23

Addresses for the Module:
The module automatically get an address when it is plugged
in. You will find below the addresses for settings in the
Central Station.
Contacts (track): 1-16
Button controller addresses: 101-164
Bus 1: 1001 -1496 (ex. 1005 = 1st module, Contact 5)
Bus 2: 2001 - 2496
Bus 3: 3001 - 3496
Examples of Settings on the Central Station:
Settings on the Central Station:
1. Use as a track contact:
1.1 Use in the Memory (example)
Go into the Configuration mode
All manuals and user guides at all-guides.com
Jump over Button
to the advanced
setting.
Select a registered
device
e.g. Contact 8
Modul 2
Bus 2
1.2 Use in the Layout (example)
Go into the Configuration mode and define the contact
Swapping Devices.
If a device swap becomes necessary, the new L88 can be
switched to the previous device number. The switch takes
place after the Link S88 registers in the CS at setup –Tool
–Devices - edit. Enter the new Link S88 there with the
previous device number and confirm this number. After that,
the CS needs to be rebooted. All of the contacts will function
as usual.
Enter address
(contact)
Select device
Select function, if
necessary
19