Aerus LAUNDRY PRO 2.0 Mode D'emploi page 6

INSTALLATION OF WALL ANCHORS OR SCREWS
1. Place the Laundry Pro 2.0 to the wall and mark the appropriate keyholes
with a pencil.
NOTE: Washing machine and cold water faucet must be
within 4 feet (1.21 m) of the right side of unit.
A. If using supplied wall anchors, drill two 3/16" (4.76 mm) diameter holes.
Place two wall anchors into the wall. Install two supplied screws and
tighten until almost all the way in.
B. If mounting to wall studs, drill two 3/32" (2.381 mm) diameter holes
approximately 1" (25.4 mm) deep. Install two supplied screws and tighten
until almost all the way in.
NOTE: The provided hardware kit contains adhesive backed rubber spacers
to be placed on back of unit to provide additional clearance from wall
if needed for hose installation or the use of ActiveClean Port. (Page 12)
2. Position the keyholes of the Laundry Pro 2.0 onto the screws (not shown).
Finish tightening screws enough to securely mount unit, but still allowing it
to be removed from wall. Remove unit from wall.
6
Screws (not shown)
17.3" (43.94 cm)
Keyholes