Aerus LAUNDRY PRO 2.0 Mode D'emploi page 12

FOR WASHERS THAT REQUIRE HOT & COLD WATER INPUT
• Turn off both water valves (hot and cold) before disconnecting hoses; Failure to follow these instructions may result in
• When connecting hoses to your Laundry Pro 2.0 hand start the hose connector(s); using adjustable pliers, finish
CAUTION
Some washing machine models require water pressure to both the Hot and Cold valves for proper operation. In some cases, if only the COLD water side is
connected, the water valve will not operate or the washing machine will not fill to the proper level. To solve this problem, the installation of a "Y" adapter (available
at most hardware stores) may be used. The use of the "Y" adapter allows water to flow equally through both the HOT and COLD water valves. Optional stainless
steel hose must be installed on the hot water connection. To Install, turn water off at the valves and disconnect the existing HOT water hose (at the valve and
washing machine). Connect the "Y" adapter to the outlet on your Laundry Pro 2.0, then connect both the optional stainless steel hose and Cold hose from your
washer to the "Y" adapter (see diagram below). Operate your washer on the WARM/WARM setting (your Laundry Pro 2.0 will still be using just cold water).
NOTE:
Your hot source water valve will not have a hose connected to it. Make sure it is fully turned off. It is recommended you secure a cap
(available at most home improvement stores) to prevent leakage.
NOTE:
The "Y" adapter needs to be purchased locally. Use only a metal adapter. DO NOT use plastic.
Connect the "Y" adapter to the OUTLET on your
Laundry Pro 2.0. Be sure to hold the fitting with pliers
while tightening the adapter.
Disconnect this stainless steel hose from
the OUTLET on your Laundry Pro 2.0, then
connect it to the "Y" adapter.
12
water leakage and/or possible injury from hot water
tightening hose connector(s)
Connect to COLD water inlet
on washing machine
Stainless steel hose supplied
with Laundry Pro 2.0.
Connect to HOT water inlet
Connect to household
plumbing COLD water valve
"Y" adapter
Make sure the "Y" adapter
valve is in the on position.
NOTE : Use a metal "Y" adapter.
Do not use plastic
Disconnect the existing hose
from the HOT valve and washing
machine and remove. Replace with
optional stainless steel hose.
on washing machine