Publicité
Les langues disponibles
Les langues disponibles
Using the Ice Maker and Cold
Water Dispenser
Working Principle
The ice content will depend on room temperature, door openings, water pressure, freezer temperature, etc.
It is considered normal when ice cubes stick together.
Wait 24 hours after installing your refrigerator before you begin using the ice maker
feature. This gives the ice maker time to load the ice bucket.
NOTE
If this is your First Ice Maker
Occasionally you may hear some sounds, like water flowing or ice dropping. These sounds are
normal. Occasionally, in periods of infrequent ice use, cubes may stick together and clog the
dispenser. Remove the ice cream holder and lift up the ice bucket. Shake it from side to side to
dislodge the cubes. Return the ice bucket and ice cream holder. Cubes should dispense normally now.
If you Do not Use Ice often
Older ice cubes can get stale. Clean the ice bucket periodically and use warm water to clean. Before
putting it back, make sure to dry it so new ice does not stick to it.
When you Do not Use the Ice Container for an extended time
If you will not be using the ice container for a long time, throw out the remaining ice cubes, wash the
container with warm water, dry it with a towel, and put it back in the refrigerator. Then close the
valve between the water supply and the refrigerator.
Using the Dispenser
Select one - crushed ice, cold water, and ice cubes - and push the ice/water lever gently as follows:
1. When you want crushed ice:
Press the selecting button until the
crushed ice indicator is lit.
Push the lever gently with the cup.
Crushed ice will be provided.
When you Use Crushed Ice
Even if you are using cubed ice, you may still get some crushed ice. This can happen when several ice cubes are
sent to the ice crusher.
Sometimes a small amount of snow or frost will form on the door in the ice chute. It is best to remove this to
prevent ice from binding in the chute.
When you Use Cold Water
When you first push the lever, cold water might not come out immediately. This is because there may be air in the
pipe. Press the lever for at least 2 minutes to clear out the air and then fill your cup with water.
The first cup of water may be warmer than the following cups. This is normal. If you take out 2 cups, or 16 oz., the
water may become warmer again.
To avoid injury, NEVER put your fingers and/or other objects in the ice dispenser
opening.
WARNING
2. When you want cubed ice:
Press the selecting button until
the cubed ice indicator is lit.
Push the lever gently with the
cup. Cubed ice will be provided.
19
3. When you want cold water:
Press the selecting button until the
cold water indicator is lit.
Push the lever gently with the cup.
Cold water will be provided.
Publicité
