Sublue WhiteShark Tini Manuel De L'utilisateur page 10

Operation Method
Items
In the shutdown state,
press the power system
Power
switch/networking button
system
for 6S to enter the
networking
2
networking mode
In the power-on state, press
Control
and hold the handle
handle
networking button for 3S to
networking
2
enter the networking mode
When it has been turned on
and successfully connected
to the network, press the
Speed level control handle
adjustment switch/speed-level
4
adjustment button to adjust
speed. The speed will be
adjusted once you press it
① In the power-on state, 1
press the power system
Power
switch/networking toggle
system
button for 3S
shutdown
② The system will be 2
11
Photos Remarks
Pressing for 3S will turn on
the power system, and
continue pressing until 6S
to enter the networking
mode. After successful
networking, it will
automatically exit this
mode
After the power system
and the control handle
are successfully
networked, press the start
button of the control
handle to exit the
networking mode
3
There are two speed
levels, and the speed level
is "low speed" after each
restart
There are two speed
levels, and the speed level
is "low speed" after each
restart
Operation Method
Items
automatically shut down without
any operation in 40 minutes
③The battery power capacity is
3
too low during operation
① Press and hold the control
1
handle switch/speed-level
adjustment button for 3S in the
To shut
power-on state
down the
② The control handle will be
2
control
automatically shut down without
handle
any operation in 10 minutes
③The battery power capacity is 3
too low during operation
After the power system and the
control handle are started and
Motor start networked, press the control
handle start button to start
propeller
* When the power system is started, please don' t do any operation on the control handle;
When the product leaves the factory, the power system and the control handle have been networked, so the
*
product can be used directly, and there is no need to carry out networking operation. When you have multiple
equipment that need to be used in combination, you can use the networking function according to your needs;
* The control handle can control multiple power systems, and for each networking, it cannot determine the
number of power systems that need to be networked, so the operator needs to judge the completion of the
power system networking based on the indicator, and then press the handle's start button to exit the networking
mode of the handle;
* The control handle and the power system can be turned on and operated independently, so there is a possibility
that the speed level display is inconsistent after being turned on. At this time, the speed level of the control handle
shall prevail, and except starting the networking mode, the control handle can perform any operation to change
the speed level of the power system to be consistent with that of the control handle.
Photos Remarks
All indicators of the
control handle are off
Press to start, release to
stop
12