Brita On Tap Mode D'emploi page 4

Thank you for choosing BRITA for great tasting filtered
water.
1
Battery slot
2
Reset button
3
Stainless steel screen (removes large impurities)
4
Rubber Gasket (prevents water leakage)
5
Attachment nut
6
Filter cartridge cap
7
Filter cartridge
8
Water setting icon
9
Water selection lever
10
Display for remaining cartridge capacity
11
Outlet for
12
Outlet for
13
Outlet for
for taps with external thread
A
22mm diameter
for taps with internal thread
B
23mm or 24mm diameter
for round taps without aerator
C
15mm to 25mm diameter
(shower)
(beam)
3
For detailed information please see page 6
Should the BRITA On Tap water filter system require
repairs or servicing, do not attempt to disassemble the
unit. Please contact the BRITA Customer Service team
in your country.
Clean the outside of the BRITA On Tap with a damp
sponge and mild washing-up liquid. Abrasive cleaners,
detergents or chrome polish may mark the finish.
The BRITA On Tap water filter system is designed to
be used only with municipally treated tap water. If an
instruction is received from the authorities that mains
water must be boiled, then BRITA filtered water must
also be boiled. When the instruction to boil water is no
longer in force, please clean the BRITA On Tap
thoroughly and insert a new cartridge.
For certain groups of people (e.g. those with impaired
immunity and babies), it is generally recommended
that tap water should be boiled; this also applies to
filtered water.
BRITA cannot accept any liability if one does not follow
the given instructions of use.
At the end of the lifetime of the BRITA On Tap water
filter system, please remember that it must be
disposed of according to the local applicable
regulations and statutory requirements as electric/
electronic waste. Please remove the filter cartridge
before disposal of the system and dispose it in normal
domestic waste.
The product contains a Litium battery which must be
disposed separately according to the local applicable
regulations and statutory requirements.